Engineering, 29.01.2020 09:40 mm016281

Calculate all reaction and member forces for the truss below. show all work in your extra sheet of paper, allowing plenty of room for fbds and calculations. make sure all work is legible and neat. be sure to list all formulas, substitutions, and solutions clearly. when you have resolved all forces, draw the fbd for the entire structure at the bottom of your graph paper, showing all applied, reaction, and member forces including type of force.

precision = 0.00 drawing not to scale

-negative 575 lbs on joint b
-roller on joint a
-puller on joint c
-6' from joint a to d
- 3' from d to c
-5' from d to b
- 4 joints
-5 members
- 3 reaction forces
-shaped as a triangle bisected by bd

1.what is the measure of angle bac?
2.what is the measure of angle bcd?
3.what is the magnitude and direction of the reaction force at roller joint a?
4.what is the force on member ab?
5.what is the force on member dc?
6.what is the force on member bc?

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

Answer

You know the right answer?

Calculate all reaction and member forces for the truss below. show all work in your extra sheet of p...

Questions