Engineering, 28.01.2020 20:50 sjwharris2668
Using phasors, the value of 37 sin 50t + 30 cos(50t – 45°) is cos(50t+° report your answer so the magnitude is positive and all angles are in the range of negative 180 degrees to positive 80 degrees
Answers: 1
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:20
Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point.the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.
Answers: 1
Engineering, 04.07.2019 19:10
An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed
Answers: 3
Engineering, 04.07.2019 19:20
The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.
Answers: 3
Using phasors, the value of 37 sin 50t + 30 cos(50t – 45°) is cos(50t+° report your answer so the...
Social Studies, 23.05.2021 14:00
English, 23.05.2021 14:00
Mathematics, 23.05.2021 14:00
Mathematics, 23.05.2021 14:00
Mathematics, 23.05.2021 14:00
Health, 23.05.2021 14:00
Mathematics, 23.05.2021 14:00
Computers and Technology, 23.05.2021 14:00
Mathematics, 23.05.2021 14:00
Mathematics, 23.05.2021 14:00
Chemistry, 23.05.2021 14:00
Computers and Technology, 23.05.2021 14:00
Mathematics, 23.05.2021 14:00