Engineering, 28.01.2020 13:40 brooke012002
Do you believe that oop should be phased out and we should start working on some alternative(s)? provide your answer with yes or no.
• give your opinion with two solid reasons to support your answer.
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 14:10
Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.
Answers: 2
Engineering, 03.07.2019 14:10
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
You know the right answer?
Do you believe that oop should be phased out and we should start working on some alternative(s)? pr...
Questions
Mathematics, 27.12.2020 01:40
Mathematics, 27.12.2020 01:40
Mathematics, 27.12.2020 01:40
History, 27.12.2020 01:40
History, 27.12.2020 01:40
History, 27.12.2020 01:40
Mathematics, 27.12.2020 01:50
Mathematics, 27.12.2020 01:50
