Engineering, 28.01.2020 07:31 almendares55

For the following environments, indicate which one would be the preferred production system (e. g., job-shop, production line, if necessary provide a one sentence support for your answer. a. manufacturer of clothes: makes many styles (shirts, pants, coats, rain jackets, etc.) and sells to small specialty stores. b. manufacturer of gaskets: makes styles for 4-5 engine blocks: sells to gm and ford (i. e., high volume). c. independent automobile service shop: body work, general service, engine repair, serving many makes of automobiles. d. producer of pharmaceutical drugs: make approximately 50-75 drugs in tablet form: sell to pharmacies nationwide.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed.gi) ifn 1, what will happen to the material when transformed material when

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

You know the right answer?

For the following environments, indicate which one would be the preferred production system (e. g.,...

Questions