Engineering, 25.01.2020 00:31 trejoste1
1) in many civil engineering calculations, water and other liquids are assumed to be incompressible. do you think this assumption is reasonable? a. report the bulk modulus of water and seawater at 60°f. b. use the definition of the bulk modulus to determine the amount of pressure in psi needed to change the density of freshwater and seawater by 5%. which one is more easily compressed? c. compare the results from part b with values for standard atmospheric pressure and for the pressure at the bottom of the mariana trench (15,750 psi). under what conditions does the incompressible assumption fail?
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
Engineering, 04.07.2019 18:20
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
Engineering, 04.07.2019 18:20
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
You know the right answer?
1) in many civil engineering calculations, water and other liquids are assumed to be incompressible....
Questions
Chemistry, 13.11.2020 05:30
Mathematics, 13.11.2020 05:30
Law, 13.11.2020 05:30
Computers and Technology, 13.11.2020 05:30
History, 13.11.2020 05:30
Mathematics, 13.11.2020 05:30
Chemistry, 13.11.2020 05:30
Law, 13.11.2020 05:30
English, 13.11.2020 05:30
