Engineering, 22.01.2020 20:31 znation1324

An engineer in a large manufacturing facility observes that some unknown liquid has seeped into an open tank of lubricating oil. the mysterious liquid is not mixing with the oil and is resting at the bottom of the tank. he or she makes some measurements, and determines that the depth of the unknown liquid is 1.5m, and that the depth of the oil is 5m. the specific weight of the oil is known to be 8500n/m3, and a pressure gage connected to the bottom of the tank reads 65kpa making appropriate assumptions, determine the following: 2. (a) the specific gravity of the unknown liquid () (b) the density of the unknown liquid (kg/m3) (c) if liquid water were to seep into the tank and didn't mix with either liquid, where would it come to rest? at the bottom? at the top? or between the oil and the oil liquid?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Air inially occupying a volume of 1 m2 at 100 kpa, 27 c undergoes three internally reversible processes in series. process 1-2 compression to 500 kpa during which pv constant process 2-3 adiabatic expanslon to 100 kpa process 3-1: constant-pressure expansion to 100 kpa (a) calculate the change of entropy for each of the three processes. (b) calculate the heat and work involved in each process. (c) is this cycle a power cycle or refrigeration cycle?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Determine (a) the maximum thermal efficiency of reversible power cycles operating between a hot reservoir at 1000°c and a cold reservoir at 200°c and (b) the maximum cops for reversible refrigeration and heat pump cycies, respectively, between 28°c and 14°c.

Answers: 1

Answer

You know the right answer?

An engineer in a large manufacturing facility observes that some unknown liquid has seeped into an o...

Questions