subject
Engineering, 14.01.2020 17:31 thicklooney

Question 54 (1 point)
the moisture of lumber to frame a house should be less than_%.
oa 8
ob 13
oc 15
od 19

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:20
Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?
Answers: 3
question
Engineering, 06.07.2019 02:30
A12 mm diameter shaft runs in a plain cylindrical bush 30 mm long that is located in an 18 mm diameter hole in a housing. the shaft-inner bush fit is h8 f and the outer bush-housing fit is h7-p6. make a fully cimensioned sketch of the bush with tolerances. find the maximum and minimum clearance or interference for both fits on the inner and outer diameters of the bush
Answers: 3
question
Engineering, 06.07.2019 03:20
Aload of 10kn is to be suddenly applied to the free end of a vertical rod of length 500 mm, the upper end being rigidly fixed. 190 mechanical science what should the diameter of the rod be if the maximum stress in the rod is not to exceed 100 mpa? the tensile modulus of the rod is 205 gpa.
Answers: 2
question
Engineering, 06.07.2019 05:10
Asteam turbine is supplied with steam at 28bar and 425c. a fraction of the steam is extracted at 1.2bar to heat the feed water in one open feed water heater. the rest of the steam expands in the low pressure stage of the turbine to 0.08bar. a)-sketch the regenerative rankine cycle with open feed water heater on the t-s diagram. b)-assuming isentropic expansion in both stages of the turbine, find the cycle efficiency. do not assume negligible pump work.
Answers: 1
You know the right answer?
Question 54 (1 point)
the moisture of lumber to frame a house should be less than_%.
oa...
Questions