Engineering, 21.12.2019 06:31 cchave9563
A2m thick extensive fill is to be placed directly onto a 2 m thick layer of saturated sandy gravel, below which is a 6m thick layer of saturated clay. the fill will have a unit weight of 20 kn/m^3 after placement. the sandy gravel layer has a unit weight of 18 kn/m3 , an initial void ratio of 0.65, a swell index of 0.008, a compression index of 0.0122, and an initial void ratio of 0.60. the clay layer has a unit weight of 15.9 kn/m^3 , an initial void ratio of 1.10, a recompression index of 0.15, and compression index of 0.378. the preconsolidation stresses for the sandy gravel and clay were estimated to be 26 kn/m^3 and 40 kn/m^3 , respectively.
1. determine the ultimate consolidation for the site due to the addition of the extensive fill. clearly state any assumptions made for your solution (you may neglect those required for the method, e. g. homogenous, isotropic, state what you are doing at each step of your solution.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 19:10
In general, how do thermosetting plastics compare to thermoplastics in mechanical and physical properties?
Answers: 3
Engineering, 04.07.2019 19:20
The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.
Answers: 3
A2m thick extensive fill is to be placed directly onto a 2 m thick layer of saturated sandy gravel,...
Mathematics, 30.03.2021 20:30
Mathematics, 30.03.2021 20:30
English, 30.03.2021 20:30
Chemistry, 30.03.2021 20:30
Computers and Technology, 30.03.2021 20:30
Mathematics, 30.03.2021 20:30
Mathematics, 30.03.2021 20:30
Business, 30.03.2021 20:30
Biology, 30.03.2021 20:30
English, 30.03.2021 20:30
Mathematics, 30.03.2021 20:30