subject
Engineering, 18.12.2019 02:31 sunny1211

An interesting observation made by the firefighters was that some parts of the forest seemed to escape the flames. the crown fire would drop down into a ground fire in these areas, and then jump back up into the canopy as the fire burned into adjacent areas. they observed that many of these areas had previously been thinned, which means that some of the trees were cut down and hauled away to be used as timber. in other areas, thinned forests burned with as much severity as the unthinned forest. your objective is to design an observational study to answer the question: what was the determining factor for areas that escaped the worst impacts of the fire, compared to areas that were severely burned? select the best hypothesis and prediction that follow from the question you’re trying to answer. for getting started, see the hints.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
question
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
question
Engineering, 04.07.2019 18:10
The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m
Answers: 2
You know the right answer?
An interesting observation made by the firefighters was that some parts of the forest seemed to esca...
Questions
question
History, 29.01.2021 18:10
question
Mathematics, 29.01.2021 18:10
question
Social Studies, 29.01.2021 18:10
question
Mathematics, 29.01.2021 18:10