subject
Engineering, 18.12.2019 02:31 layla8993

A33.8-lb aluminum bar, initially at 200 degree f, is placed in a tank together with 249 lb of liquid water, initially at 70 degree f, and allowed to achieve thermal equilibrium. the aluminum bar and water can be modeled as incompressible with specific heats 0.216 btu/lb*degree rankine and 0.998 btu/lb*degree rankine, respectively. for the aluminum bar and water as the system, determine:
(a) the final temperature, in degree f
(b) the amount of entropy produced within the tank, in btu/degree rankine.
note: ignore heat transfer between system and its surroundings

( (a) 533.7 r, (b) 0.1789 btu/r )

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
question
Engineering, 04.07.2019 18:20
Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t
Answers: 3
question
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
question
Engineering, 04.07.2019 18:20
Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.
Answers: 2
You know the right answer?
A33.8-lb aluminum bar, initially at 200 degree f, is placed in a tank together with 249 lb of liquid...
Questions
question
History, 22.08.2019 16:30
question
Mathematics, 22.08.2019 16:30
question
Mathematics, 22.08.2019 16:30