You are asked to look into adding a circuit for a new pump in the butler-carlton hydraulics lab. after some investigation of the electrical service in the building you find that there are a few voltage options; 120v, single-phase; 208v, single-phase; 208v, 3-phase, 277v, single-phase; 480v, 3-phase. which pump electrical choice would be the least economical in terms of first cost for electrical construction materials and overall electrical efficiency

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.