Engineering, 16.12.2019 20:31 cahree

Imagine you have been hired as a consulting engineer by a city to investigate the possible use of landfill gas generated by the expected decomposition of different types of municipal solid waste. for your calculations, assume maximum theoretical landfill gas production will be applicable by neglecting the production of new bacterial cells as described in our textbook. (a) estimate the percent (by volume) of landfill gas that is methane from a rapidly decomposing waste with an assumed composition of c68h111o50n. (b) estimate the percent (by volume) of landfill gas that is methane from waste hardwood lumber, which has an assumed composition of c88h126o55n3.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?

Answers: 2

Answer

Engineering, 06.07.2019 03:20

What is the strain energy stored in a solid uniformly circular shaft of length 3.0 m and diameter 120 mm when subject to pure torsion if the maximum shear stress is 40 mpa? g-80gpa

Answers: 1

Answer

You know the right answer?

Imagine you have been hired as a consulting engineer by a city to investigate the possible use of la...

Questions