subject
Engineering, 13.12.2019 21:31 dumngirl2504

At krispy kreme the process for sugar coating donuts by the sugar-waterfall donut coater involves a flow of uncoated donuts into the donut coater and the output consists of the sugar coated donuts. the coater also receives an inflow of sugar suspension which coats the donuts. the unused sugar suspension is recycled to a mixer which is positioned ahead of the donut coater. an input pipe goes into the mixer and supplies sugar suspension which replaces the sugar that coats the donuts and leaves the system. the flow rate of donuts into the coater is 1200 donuts/hr and each uncoated donut weights approximately 110 g. 12 kg/h of sucrose suspension leaves the system when the donuts are coated but most of the sugar is recycled through the mixer. the mixer output stream of sucrose suspension has a mass flow rate of 126 kg/hr.

a. create a process flow diagram of the donut coater system described above, labeling the input mass flow of sugar suspension as m1 and the output flow of coated donuts as m2, and the recycle flow as m3. label the output mass fractions of donuts and sugar suspension using as few variables as possible. (5 points)
b. what is the mass flow of coated donuts? (5 points)
c. what is the mass flow of input sugar suspension (5 points)
d. what is the mass flow of the recycled sugar suspension (5 points)
e. what is the mass fraction of sugar suspension on the coated donuts? (5 points)

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
question
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
question
Engineering, 04.07.2019 18:10
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
You know the right answer?
At krispy kreme the process for sugar coating donuts by the sugar-waterfall donut coater involves a...
Questions
question
Mathematics, 21.04.2020 20:34
question
Mathematics, 21.04.2020 20:34