subject
Engineering, 11.12.2019 19:31 evelynalper08

Problem 9.020 a thin-walled container ( 200 mm) with a hot process fluid at [infinity] 55°c is placed in a quiescent, cold water bath at [infinity] 10°c. heat transfer at the inner and outer surfaces of the container may be approximated by free convection from a vertical plate. determine the overall heat transfer coefficient between the hot process fluid and the cold water bath, in w/m2·k. assume the properties of the hot process fluid are those of water. initially assume [infinity] [infinity] and evaluate the properties of the hot process fluid and the cold water bath at the film temperatures for the respective container surfaces. use the churchill and chu correlation for nusselt number on a vertical plate.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
question
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
question
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
question
Engineering, 04.07.2019 18:20
Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.
Answers: 2
You know the right answer?
Problem 9.020 a thin-walled container ( 200 mm) with a hot process fluid at [infinity] 55°c is place...
Questions
question
History, 22.08.2021 21:20
question
Mathematics, 22.08.2021 21:20
question
Mathematics, 22.08.2021 21:20