subject
Engineering, 10.12.2019 21:31 milkshakegrande101

Awastewater treatment plant uses an activated sludge process for secondary treatment of 0.300 m3 /s of primary effluent. the mixed liquor has a biomass concentration of 2,100 mg vss/l, and the ras biomass concentration is 10,000 mg vss/l. the substrate concentration in the primary effluent (i. e., s0) is 220 mg bod5/l. the f/m ratio for the activated sludge tank is 0.52 mg bod5/(mg vss * d), and the cell residence time is 9.0 d.
a. what is the volume of the activated sludge tank?
b. what is the was flow rate?

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
question
Engineering, 04.07.2019 18:20
Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t
Answers: 3
question
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
question
Engineering, 04.07.2019 19:10
Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)
Answers: 3
You know the right answer?
Awastewater treatment plant uses an activated sludge process for secondary treatment of 0.300 m3 /s...
Questions
question
History, 27.01.2020 19:31
question
German, 27.01.2020 19:31