subject
Engineering, 07.12.2019 21:31 angeldaughter0620

Asignal m1(t) is band-limited to 3.6khz, and three other signals – m2(t), m3(t) and m4(t) are band-limited to 1.2khz each. these signals are to be transmitted by means of time division multiplexing. the scheme below shows how the multiplexing requirement may be accomplished.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
question
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
question
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
You know the right answer?
Asignal m1(t) is band-limited to 3.6khz, and three other signals – m2(t), m3(t) and m4(t) are band-l...
Questions
question
English, 06.05.2021 17:40
question
Mathematics, 06.05.2021 17:40
question
Mathematics, 06.05.2021 17:40
question
Computers and Technology, 06.05.2021 17:40