subject
Engineering, 06.12.2019 01:31 nulledcracker12

You purchased a computer with the following features: • 95% of all memory accesses are found in the cache.• each cache block is two words, and the whole block is read on any miss.• the processor sends references to its cache at the rate of 109 words per second.• 25% of those references are writes.• assume that the memory system can support 109 words per second, reads or writes.• the bus reads or writes a single word at a time (the memory system cannot read or write two words at once).• assume at any one time, 30% of the blocks in the cache have been modified.• the cache uses write allocate on a write miss.• you are considering adding a peripheral to the system, and you want to know how much of the memory system bandwidth is already used. calculate the percentage of memory system bandwidth used on the average in the two cases below. be sure to state your assumptions. a. case 1: the cache is write through. b. case 2: the cache is write back.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
question
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
question
Engineering, 04.07.2019 18:20
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
question
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
You know the right answer?
You purchased a computer with the following features: • 95% of all memory accesses are found in the...
Questions
question
Mathematics, 10.03.2021 21:20
question
Mathematics, 10.03.2021 21:20
question
Mathematics, 10.03.2021 21:20
question
Chemistry, 10.03.2021 21:20
question
History, 10.03.2021 21:20
question
Mathematics, 10.03.2021 21:20