subject
Engineering, 05.12.2019 23:31 lkipjjjjjjjjjj2272

Astudent team is to design a human-powered submarine for a design competition. the overall length of the prototype submarine is 4.85 m, and its student designers hope that it can travel fully submerged through water at 0.440 m/s. the water is freshwater (a lake) at t = 15°c. the design team builds a one-fifth scale model to test in their university’s wind tunnel (fig. p7–34). a shield surrounds the drag balance strut so that the aerodynamic drag of the strut itself does not influence the measured drag. the air in the wind tunnel is at 25°c and at one standard atmosphere pressure. at what air speed do they need to run the wind tunnel in order to achieve similarity?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
question
Engineering, 04.07.2019 18:20
Aheavily insulated piston-cylinder device contains 0.02 m3 of steam at 300 kpa and 200 °c. 1.2 mpa. d this process. team is now compressed in a reversible manner to a pressure of etermine the entropy change and the work done on the steam during this process
Answers: 1
You know the right answer?
Astudent team is to design a human-powered submarine for a design competition. the overall length of...
Questions
question
Chemistry, 23.03.2021 18:00
question
Mathematics, 23.03.2021 18:00
question
Mathematics, 23.03.2021 18:00
question
Mathematics, 23.03.2021 18:00