subject
Engineering, 05.12.2019 04:31 erikacastro5404

Afour-lane freeway (two 12-ft wide lanes in each direction) is located on rolling terrain and has a design speed of 70 mph, and no lateral obstructions are within 8 ft of the pavement edges. the traffic stream consists of cars and trucks only (no buses or recreation vehicles). a weekday peak hour volume of 1800 vehicles is observed, with 500 arriving in the most congested 15-minute period. if a level of service no worse than c is desired, determine the maximum number of trucks that can be presented in the peak hour traffic volume.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
question
Engineering, 04.07.2019 19:10
What are the major differences between injection molding and extrusion?
Answers: 2
question
Engineering, 04.07.2019 19:10
A)-in the process of engineering design, explain the contribution of material selection. b)- explain the procedure of synthesis as is employed in engineering design. c)- is there any relationship between ergonomics and engineering design? explain. d)- safety consideration in engineering design includes human, product and the enviroment . explain how safety will be incorporated into the design?
Answers: 3
You know the right answer?
Afour-lane freeway (two 12-ft wide lanes in each direction) is located on rolling terrain and has a...
Questions
question
English, 31.01.2020 19:56