Engineering, 05.12.2019 04:31 dyhji

Arectangular well-mixed aeration lagoon is 60m long, 5m wide, and 2m deep. it receives 400 cubic meters/day of wastewater with a bod5 of 336mg bod5/l for treatment. the biodegradation rate constants for the wastewater are yield coefficient = 0.8mg vss/mg bod5, endogenous decay constant=0.08 d^(-1), maximum specific microbial growth rate =1.10 d^(-1), and the half velocity constant = 76.0mg bod5/l. the pond's efficiency depends on oxygen being always available for the microbes to use in degrading the wastewater organic carbon. how much oxygen (in kg) must be supplied daily to the pond?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t

Answers: 3

Answer

You know the right answer?

Arectangular well-mixed aeration lagoon is 60m long, 5m wide, and 2m deep. it receives 400 cubic met...

Questions