subject
Engineering, 03.12.2019 22:31 hardwick744

Alarge reservoir supplied water for a community. a portion of the water supply system is shown below. water is pumped from the reservoir to a large storage tank before being sent on to the water treatment facility. the system is designed to provide 1310 l/s of water at 20 °c. from b to c, the system consists of a square-edged entrance, 760m of pipe, three gate valves, four 45 elbows, and two "c elbows. gage pressure at gate valves, and four 90° elbows. all pipe is 508mm diameter, cast iron. calculate the average velocity of water in the pipe, the gage pressure at section f, the power input to the pump (its efficiency is 80%) and the wall shear stress in section fg. ㅡㅡ z-174 m 152 m pump 91 m-

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
question
Engineering, 04.07.2019 18:10
Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk
Answers: 1
question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
question
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
You know the right answer?
Alarge reservoir supplied water for a community. a portion of the water supply system is shown below...
Questions
question
History, 21.07.2019 20:30
question
Mathematics, 21.07.2019 20:30
question
Mathematics, 21.07.2019 20:30