subject
Engineering, 03.12.2019 21:31 stdntlogin3206

Technician a says that carbon monoxide (co) and hydrocarbon (hc)
levels should increase if the air injection reactor (air) hoses are pinched off.
technician b says that a defective drive belt may cause air system
problems. who is correct?
a. technician a
b. both technicians a and b
c. technician b
d. neither technician a nor b
15. which of these items will least likely increase pressure in the
evaporative emission control system?
a. returned fuel from the fuel-injection system
b. inlet fuel to the fuel pump
c. fuel temperature
d. volatility of the fuel
12. as the efficiency of the catalytic converter drops through deterioration,
the switching rate of the rear o2 sensor signal will start to look like the front
o2 sensor signal. when the rear o2 sensor signal reaches approximately 75
percent of the front o2 sensor, which of the following is the result?
a. the catalyst beads in the converter should be changed.
b. the diagnostic trouble code is stored with the mil on.
c. the catalytic converter should be replaced.
d. a one-trip flag is set with a code stored, but the mil isn't activated.
7. which of these engine concerns may be caused by a stuck-open
exhaust gas recirculation (egr) valve?
a. ping (spark knock or detonation)
b. engine missing at highway speed
c. excessive nox exhaust emissions
d. rough idle/stalling

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.
Answers: 2
question
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
question
Engineering, 04.07.2019 18:10
The higher the astm grain size number, the finer the gran is. a)-true b)-false
Answers: 2
question
Engineering, 04.07.2019 18:10
Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.
Answers: 1
You know the right answer?
Technician a says that carbon monoxide (co) and hydrocarbon (hc)
levels should increase if the...
Questions
question
Mathematics, 20.11.2019 12:31
question
English, 20.11.2019 12:31
question
Mathematics, 20.11.2019 12:31
question
Mathematics, 20.11.2019 12:31