Engineering, 03.12.2019 19:31 kody2lewiskl
Aservomechanism position control has the plant transfer function g(s) = 10/s(s + 1)(s + 10)
you are to design a series compensation transfer function dc(s) in the unity feedback configuration to meet the following closed-loop specifications .
the response to a reference step input is to have no more than 16% overshoot. the response to a reference step input is to have a rise time of no more than 0.4 sec.
the steady -state error to a unit ramp at the reference input must be less than 0.05.
(a) design a lead compensation that will cause the system to meet the dynamic response specifications, ignoring the error requirement
(b) what is the velocity constant kv for your design? does meet the error specification?
(c) design a lag compensation to be used in series with the lead you have designed to cause the system to meet the steady-state error specification.
(d) give the matlab plot of the root locus of your final design.
(e) give the matlab response of your final design to a reference step.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79
Answers: 1
Engineering, 04.07.2019 18:10
The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m
Answers: 2
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
You know the right answer?
Aservomechanism position control has the plant transfer function g(s) = 10/s(s + 1)(s + 10)
Questions
