Engineering, 03.12.2019 05:31 trellizzz

Nairplane flies at a speed of 400-mph at an altitude of 10,000 ft. if the boundary layers on thewing surfaces behave as those on a flat plate, estimate the extent of laminar boundary layer flowalong the wing. assume a transitionalreynolds number of rexcr

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 03:10

What precautions should you take to prevent injuries when dealing with heavy loads?

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

Engineering, 04.07.2019 19:20

To save energy, the air supply to a 2000 ft office has been shut off overnight and the room temperature has dropped to 40°f. in the morning, the thermostat is reset to 70°f and warm air at 120 f begins to flov in at 200ft'/min. the air is well mixed within the room, and an equal mass flow of air at room temperature (changing with time) is withdrawn through a return duct. the air pressure is nearly 1 atm everywhere. ignoring heat transfer with the surroundings and kinetic and potential energy effects, estimate how long it takes for the room temperature to reach 70°f. plot the room temperature as a function of time.

Answers: 1

Answer

You know the right answer?

Nairplane flies at a speed of 400-mph at an altitude of 10,000 ft. if the boundary layers on thewing...

Questions