Engineering, 02.12.2019 21:31 gujacksongu6

To study the connection between rectification and diode characteristics from a datasheet to plot a pn junction diode characteristic using an oscilloscope, to plot diode character- istics with a shockley diode equation and then to compare the latter.

1) explain the properties of the circuit a results. how does the switch voltage affect these results?

2) how does the switch voltage in the results from circuit b compare to that expected from the datasheet? compare this latter curve to the curve produced in the prelab.

3) if you were going to use a constant voltage model for design with this diode, what switch voltage would you select?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

Answer

Engineering, 04.07.2019 19:10

An electric kettle is made out of stainless steel, weighs two pounds (when empty) and is equipped with a heating element that consumes 2 kw of electricity. assuming that the water and the kettle are at the same uniform temperature at any moment of time, calculate the shortest possible time to bring 2 quarts of water from room temperature to the onset of boiling

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

Answer

You know the right answer?

To study the connection between rectification and diode characteristics from a datasheet to plot a p...

Questions

SAT, 20.11.2021 07:30

Write a balanced half-reaction for the reduction of aqueous nitrous acid to gaseous nitric oxide in basic aqueous solution. Be sure to add physical st...