Engineering, 28.11.2019 01:31 Naviascales1681

Hot oil (cp, oil = 2.13 kj/kg k) is to be cooled by water (cp, water = 4.18 kj/kg k) in a shell and tube heat exchanger with one pass of shell and eight passes of tube. the tubes are thin-walled and made of copper with an internal diameter of 1.4 cm. the length of each tube pass in the heat exchanger is 5 m, and the overall heat transfer coefficient is 310 w/m2k. water flow through the tubes at a rate of 0.2 kg/s and the oil through the shell at a rate of 0.3 kg/s. the water and the oil enter at temperatures of 20°c and 150°c, respectively. determine the rate of heat transfer in the heat exchanger and the outlet temperatures of the water and the oil.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Apure substance is a)-mixture of various chemical elements or compounds b)-substance that has a fixed chemical composition throughout c)-mixture that is homogeneous (such as air) d)-all the answers

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Air enters a horizontal, constant-diameter heating duct operating at steady state at 290 k, 1 bar, with a volumetric flow rate of 0.25 m°/s, and exits at 325 k, 0.95 bar. the flow area is 0.04 m2. assuming the ideal gas model with k = 1.4 for the air, determine (a) the velocity at the inlet and exit, each in m/s, and (c) the rate of heat transfer, in kw flow rate, in kg/s, (b) the mass kg 0.3

Answers: 2

Answer

You know the right answer?

Hot oil (cp, oil = 2.13 kj/kg k) is to be cooled by water (cp, water = 4.18 kj/kg k) in a shell and...

Questions