subject
Engineering, 28.11.2019 00:31 stephany5439

Pseudomonas methylotrophus is used to produce single cell protein from methanol in a 1000-m3 pressure-cycle airlift fermenter. the biomass yield from substrate is 0.41 g g 1, ks is 0.7 mg l 1, and the maximum specific growth rate is 0.44 h 1. the medium contains 4% (w/v) methanol. a substrate conversion of 98% is desirable. the reactor may be operated in either batch or continuous mode. if operated in batch, an inoculum of 0.01% (w/v) is used and the downtime between batches is 20 h. if continuous operations are used at steady state, a downtime of 25 days is expected per year.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79
Answers: 1
question
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
question
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
Pseudomonas methylotrophus is used to produce single cell protein from methanol in a 1000-m3 pressur...
Questions
question
SAT, 09.12.2021 03:20