Engineering, 28.11.2019 00:31 Cinders13

Verify that the line integral and the surface integral of stokes' theorem are equal for the following vector field, surface s, and closed curve c. assume that c has counterclockwise orientation and s has a consistent orientation. fequalsleft angle y comma font size decreased by 6 minus x comma font size decreased by 6 7 right angle; s is the upper half of the sphere x squaredplusy squaredplusz squaredequals4 and c is the circle x squaredplusy squaredequals4 in the xy-plane. construct the line integral of stokes' theorem using the parameterization r(t)equalsleft angle 2 cosine t comma font size decreased by 6 2 sine t comma font size decreased by 6 0 right angle, for 0less than or equalstless than or equals2pi for the curve c. choose the correct answer below. a. integral from 0 to 2 pi 4 font size decreased by 6 dt b. integral from 0 to 2 pi minus 4 font size decreased by 6 dt c. integral from 0 to 2 pi 8 font size decreased by 6 dt d. integral from 0 to 2 pi minus 8 font size decreased by 6 dt

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point.the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s

Answers: 2

Answer

You know the right answer?

Verify that the line integral and the surface integral of stokes' theorem are equal for the followin...

Questions