Engineering, 27.11.2019 22:31 kghmgfxn3292

Abrass alloy is known to have a yield strength of 275 mpa (40,000 psi), a tensile strength of 380 mpa (55,000 psi), and an elastic modulus of 103 gpa (15.0×106 psi). a cylindrical specimen of this alloy 6.4 mm (0.25 in.) in diameter and 217 mm (8.55 in.) long is stressed in tension and found to elongate 5.0 mm (0.20 on the basis of the information given, is it possible to compute the magnitude of the load that is necessary to produce this change in length? if not, explain why.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.

Answers: 2

Answer

You know the right answer?

Abrass alloy is known to have a yield strength of 275 mpa (40,000 psi), a tensile strength of 380 mp...

Questions