subject
Engineering, 27.11.2019 22:31 o11011195

Consider a non-ideal (e. g. a realistic junction with fermi level pinning) tungsten schottky barrier on silicon having a constant donor density the junction will be a low-resistance ohmic contact that can pass high currents by tunneling if the barrier presented to the electrons is thin enough. we assume that the onset of efficient tunneling occurs when the fermi level extrapolated from the metal meets the edge of the conduction band at a distance no larger than 9 nm from the interface.(a) what is the minimum nd such that this condition would be met at equilibrium? (b) draw a sketch of the energy band diagram under the condition of (a). (c) assume that nd is increased four times from (a). by what factor is the tunneling distance (wdep) reduced? and by what factor is re reduced?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
question
Engineering, 04.07.2019 18:10
The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false
Answers: 1
question
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
question
Engineering, 04.07.2019 18:10
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
You know the right answer?
Consider a non-ideal (e. g. a realistic junction with fermi level pinning) tungsten schottky barrier...
Questions
question
Mathematics, 21.02.2020 23:06