Engineering, 26.11.2019 23:31 sccovell5601
Problem 12. the design of the gear and shaft system requires that steel shafts of the same diameter be used for both ab and cd. it is further required that ߬௫ 60 mpa, and that the angle ߶ through which end d of shaft cd rotates not exceed 1.5°. knowing that g=77.2 gpa, determine the required diameter of the shafts.
Answers: 3
Engineering, 03.07.2019 15:10
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 08:10
Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed
Answers: 1
Problem 12. the design of the gear and shaft system requires that steel shafts of the same diameter...
Mathematics, 10.06.2021 09:50
Mathematics, 10.06.2021 09:50
Chemistry, 10.06.2021 09:50
Mathematics, 10.06.2021 09:50
Mathematics, 10.06.2021 09:50
Mathematics, 10.06.2021 09:50
Mathematics, 10.06.2021 09:50
Mathematics, 10.06.2021 09:50
Mathematics, 10.06.2021 09:50
Engineering, 10.06.2021 14:00
Mathematics, 10.06.2021 14:00
Social Studies, 10.06.2021 14:00