Engineering, 26.11.2019 06:31 mayaa2351
Agas turbine for an automobile is designed with a regenerator. air enters the compressor of this
engine at 100 kpa and 20°c. the compressor pressure ratio is 8; the maximum cycle temperature is
800°c; and the cold air stream leaves the regenerator 10°c cooler than the hot air stream at the inlet
of the regenerator. assuming both the compressor and the turbine to be isentropic, determine the
rates of heat addition and rejection for this cycle when it produces 150 kw. use constant specific
heats at room temperature. draw a t-s diagram of the engine
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer
Answers: 2
Engineering, 04.07.2019 19:10
The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object
Answers: 1
Engineering, 04.07.2019 19:10
The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false
Answers: 2
Engineering, 04.07.2019 19:10
Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.
Answers: 1
You know the right answer?
Agas turbine for an automobile is designed with a regenerator. air enters the compressor of this
Questions
English, 11.10.2020 16:01
Mathematics, 11.10.2020 16:01
Law, 11.10.2020 16:01
Chemistry, 11.10.2020 16:01
English, 11.10.2020 16:01
Chemistry, 11.10.2020 16:01
