subject
Engineering, 26.11.2019 03:31 jamayeah02

Building a module 10 points in the optimization lessons, our frequent tasks included finding zeroes, minima, derivatives, and integrals. in this assignment, you will build a small self-contained module which is capable of accepting a function and returning the following: 1. a zero. 2. the global minimum, found by brute force. 3. the local minimum starting from 0, found by hill climbing. 4. the derivative of the function at a given point. 5. the integral of the function from 0 to a given point. pretend that the text entry box is the entire script itself defining your module. the autograder will check for the presence and function of each part of your module independently. we won't test this with pathological functions that don't have answers (like y a); well stick to well-behaved functions like y21 and y sinz.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false
Answers: 3
question
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
question
Engineering, 04.07.2019 18:10
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
question
Engineering, 06.07.2019 02:30
A12 mm diameter shaft runs in a plain cylindrical bush 30 mm long that is located in an 18 mm diameter hole in a housing. the shaft-inner bush fit is h8 f and the outer bush-housing fit is h7-p6. make a fully cimensioned sketch of the bush with tolerances. find the maximum and minimum clearance or interference for both fits on the inner and outer diameters of the bush
Answers: 3
You know the right answer?
Building a module 10 points in the optimization lessons, our frequent tasks included finding zeroes,...
Questions