Engineering, 25.11.2019 20:31 frandariusscott
For a hollow round tubing with outer diameter do= 6 in and wall thickness t= 0.25 in that is welded to a plate with a fillet weld size â„Ž = 0.25 in and weld strength sweld = 50 ksi, assume that failure occurs only in the weld. for the following loading conditions calculate the allowable force or moment before failure:
a.) axial loading, calculate fallow[#]
b.) pure bending, calculate mallow [in#]
c.) pure torsion, calculate tallow [in#]
Answers: 1
Engineering, 04.07.2019 18:10
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
Engineering, 04.07.2019 18:10
The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m
Answers: 2
For a hollow round tubing with outer diameter do= 6 in and wall thickness t= 0.25 in that is welded...
Advanced Placement (AP), 08.07.2021 20:30
Mathematics, 08.07.2021 20:30
History, 08.07.2021 20:30
Computers and Technology, 08.07.2021 20:30
Mathematics, 08.07.2021 20:30
History, 08.07.2021 20:30
Mathematics, 08.07.2021 20:30
Chemistry, 08.07.2021 20:30
Mathematics, 08.07.2021 20:30
Mathematics, 08.07.2021 20:30