Engineering, 20.11.2019 23:31 delanieloya
Amodel of a submarine, 1: 15 scale, is to be tested at 180 ft/s in a wind tunnel with standard sea-level air, while theprototype will be operated in seawater. determine the speed ofthe prototype to ensure reynolds number similarity‘
Answers: 1
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
Engineering, 04.07.2019 18:10
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Amodel of a submarine, 1: 15 scale, is to be tested at 180 ft/s in a wind tunnel with standard sea-l...
English, 18.10.2019 20:30
Mathematics, 18.10.2019 20:30
Mathematics, 18.10.2019 20:30
History, 18.10.2019 20:30
Advanced Placement (AP), 18.10.2019 20:30
Mathematics, 18.10.2019 20:30
Physics, 18.10.2019 20:30
Mathematics, 18.10.2019 20:30