subject
Engineering, 16.11.2019 06:31 sethhdoty

A20,000-liter storage tank was taken out of service to repair and reattach a feed line damaged in a collision with a tanker. the tank was drained and then opened several days later for a welder to enter and perform the required work. no one realized, however, that 5 liters of liquid nonane (c9h20) remained in a collection sump at the bottom of the tank after the draining had been completed.

(a)

nonane has a lower explosive limit of 0.80 mole% and an upper explosive limit of 2.9 mole%8 (i. e., nonane-air mixtures at 1 atm can explode when exposed to a spark or flame if the nonane mole fraction is between the two given values). assume any liquid nonane that evaporates spreads uniformly throughout the tank. is it possible for the average gas-phase composition in the tank to be within the explosive limits at any time? even when the average composition falls outside those limits, why is an explosion still a possibility?

(hint: think about that assumption.)

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
question
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
question
Engineering, 04.07.2019 18:10
Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.
Answers: 2
question
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
You know the right answer?
A20,000-liter storage tank was taken out of service to repair and reattach a feed line damaged in a...
Questions
question
Mathematics, 11.01.2021 20:30
question
Mathematics, 11.01.2021 20:30