Engineering, 12.11.2019 03:31 ttrinityelyse17
Air enters the compressor of an air-standard brayton cycle with regeneration at 100 kpa and 300 k, with a mass flow rate of 6 kg/s. the compressor pressure ratio is 10 while the turbine inlet temperature is 1400 k. the turbine and compressor each have an isentropic efficiency of 80%, while the regenerator effectiveness is 80%. assuming constant properties evaluated at 300 k determine:
a) the thermal efficiency of the cycle
b) the back-work ratio
c) the net power produced, in kw
d) the rate of entropy generation in the regenerator, in kw/k.
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
Engineering, 04.07.2019 18:20
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
You know the right answer?
Air enters the compressor of an air-standard brayton cycle with regeneration at 100 kpa and 300 k, w...
Questions
Physics, 26.10.2019 17:43
Social Studies, 26.10.2019 17:43
Biology, 26.10.2019 17:43
Mathematics, 26.10.2019 17:43
Mathematics, 26.10.2019 17:43
