subject
Engineering, 12.11.2019 00:31 Izayoi

Gyou are cold drawing a steel wire from 2 mm to 1.8 mm with a carbide die. the pulling velocity is 0.75 m/s. the coefficient () is 0.12. the die angle () is 4 degrees. for steel, k = 695 mpa and n = 0.32. there is no back stress in this process. a) determine if this draw is possible. b) determine the pulling force. c) determine the power.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
question
Engineering, 04.07.2019 18:10
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
question
Engineering, 04.07.2019 18:10
Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer
Answers: 2
You know the right answer?
Gyou are cold drawing a steel wire from 2 mm to 1.8 mm with a carbide die. the pulling velocity is 0...
Questions
question
Mathematics, 30.06.2019 14:50
question
Mathematics, 30.06.2019 14:50