subject
Engineering, 07.11.2019 00:31 jmonee

Safety application

a 20,000-liter storage tank was taken out of service to repair and reattach a feed line damaged in a collision with a tanker. the tank was drained and then opened several days later for a welder to enter and perform the required work. no one realized, however, that 5 liters of liquid nonane (c9h20) remained in a collection sump at the bottom of the tank after the draining had been completed.

(a)

nonane has a lower explosive limit of 0.80 mole% and an upper explosive limit of 2.9 mole%8 (i. e., nonane-air mixtures at 1 atm can explode when exposed to a spark or flame if the nonane mole fraction is between the two given values). assume any liquid nonane that evaporates spreads uniformly throughout the tank. is it possible for the average gas-phase composition in the tank to be within the explosive limits at any time? even when the average composition falls outside those limits, why is an explosion still a possibility?

(hint: think about that assumption.)

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet
Answers: 3
question
Engineering, 04.07.2019 18:10
True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure
Answers: 2
question
Engineering, 04.07.2019 18:20
Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms
Answers: 2
question
Engineering, 04.07.2019 19:10
Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)
Answers: 3
You know the right answer?
Safety application

a 20,000-liter storage tank was taken out of service to repair and re...
Questions
question
History, 25.03.2020 05:04
question
Mathematics, 25.03.2020 05:04
question
Biology, 25.03.2020 05:04
question
Mathematics, 25.03.2020 05:04