subject
Engineering, 05.11.2019 00:31 kymmyaboss2

Afuel oil is fed to a furnace and burned with 25.0% excess air. the oil contains 87.0 wt% c, 10.0% h, and 3.00% s. analysis of the furnace exhaust gas shows only n2, o2, co2, so2, and h2o. the sulfur dioxide emission rate is to be controlled by passing the exhaust gas through a scrubber in which most of the so2 is absorbed in an alkaline solution. the gases leaving the scrubber (all of the n2, o2, and co2, and some of the h2o and so2 entering the unit) pass out to a stack. the scrubber has a limited capacity, however, so that a fraction of the furnace exhaust gas must be bypassed directly to the stack. at one point during the operation of the process, the scrubber removes 90.0% of the so2 in the gas fed to it, and the combined stack gas contains 634.5 ppm (parts per million) so2 on a dry basis; that is, every million moles of dry stack gas (i. e. not including the water) contains 634.5 moles of so2. we wish to calculate the fraction of the exhaust bypassing the scrubber at that moment.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false
Answers: 2
question
Engineering, 04.07.2019 18:10
Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?
Answers: 3
question
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
question
Engineering, 04.07.2019 18:10
The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody
Answers: 2
You know the right answer?
Afuel oil is fed to a furnace and burned with 25.0% excess air. the oil contains 87.0 wt% c, 10.0% h...
Questions