electrodes for out-of-position welding.
Engineering, 04.11.2019 20:31 sanchezp0821
2. list three advantages of using smaller diameter
electrodes for out-of-position welding.
3. why is the lowest bendin encher made first
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1
Answers: 1
Engineering, 04.07.2019 18:20
Modern high speed trains do not have perpendicular expansion gaps where rails are joined end-to-end any more they are mostly welded together but what might happen if there was a spell of particularly hot weather that causes inspection of the tracks?
Answers: 1
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
You know the right answer?
2. list three advantages of using smaller diameter
electrodes for out-of-position welding.
electrodes for out-of-position welding.
Questions
Chemistry, 12.02.2021 23:10
Computers and Technology, 12.02.2021 23:10
Spanish, 12.02.2021 23:10
Chemistry, 12.02.2021 23:10
Mathematics, 12.02.2021 23:10
Computers and Technology, 12.02.2021 23:10
Mathematics, 12.02.2021 23:10
Mathematics, 12.02.2021 23:10
Social Studies, 12.02.2021 23:10
Mathematics, 12.02.2021 23:10
