Engineering, 02.11.2019 06:31 jayv1999

Ajet boat takes in water at a constant rate q through the side vents and ejects water at a high jet speed, vj, at the rear. vj is measured relative to the speed of the boat. a variable area exit orifice controls the jet speed. the drag force on the boat is given by d = kv2, where k is a constant and v is the boat speed (measured by a stationary observer). assume steady, incompressible flow that is uniform across inlets and outlets. v = 12 m/s when vj = 30 m/s. a.find an expression for v in terms ofvj. b. what vj is needed to produce a boat speed of 22 m/s?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

Answer

Engineering, 06.07.2019 02:30

On solidification from a melt, the polymer polyethylene forms a semi-crystalline spherulite structure. (i) sketch an individual spherulite and label the amorphous and crystalline regions. (ii) draw a schematic to show the changes in specific volume with temperature during cooling from the melt, comparing it to the theoretical extremes of fully crystalline and fully amorphous (indicate tm and tg)

Answers: 2

Answer

Engineering, 06.07.2019 02:30

A75mm diameter shaft is supported in a journal bearing 75mm long with a diametral clearance of 0. 1mm. it supports a radial load of 1000 n and is lubricated with sae 50 oil at 70°c. find the friction torque and the power loss when the crankshaft rotates at 2900 rev/min.

Answers: 1

Answer

You know the right answer?

Ajet boat takes in water at a constant rate q through the side vents and ejects water at a high jet...

Questions