Engineering, 29.10.2019 23:31 krystenlitten

In large steam power plants, the feedwater is
frequently heated in closed feedwater heaters,
which are basically heat exchanges, by steam
extracted from the turbine at some stage. steam
enters the feedwater heater at 1 mpa and 200 oc
and leaves as saturated liquid at the same pressure.
feedwater enters the heaters at 2.5 mpa and 50 oc
and leaves 10oc below the exit temperature of the
steam. neglecting any heat losses from the outer
surfaces of the heater, determine (a) the ratio of the
mass flow rates of the extracted steam and the
feedwater heater and (b) the total entropy change
for this process per unit mass of the feedwater.

answers: (a. 0.247, b. 0.213 kw/(k kgfw))

also if you could draw what this system looks like that would be great.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor

Answers: 3

Answer

You know the right answer?

In large steam power plants, the feedwater is
frequently heated in closed feedwater heaters,

Questions