subject
Engineering, 28.10.2019 21:31 fezez5304

Consider a cmos process for which lmin=0.25um, tox=6nm, mn=460 cm2/v s and vt=0.5v (from problems 5.10)

a,) find cox, and kn’
b.) for an nmos transistor with w/l=15um/0.25um, calculate the values of vov, vgs, and vdsmin needed to operate the transistor in the saturation region with a dc current id=0.8ma.
c.) for the device in (b), find the value of vov and vgs required to cause the device to operate as a 500 w resistor for very small vds.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
question
Engineering, 04.07.2019 19:10
What is the major difference between thermoplastics and thermosetting plastics from the polymerization structure point of view?
Answers: 2
question
Engineering, 04.07.2019 19:10
Agas contained within a piston-cylinder assembly e end nation about same energy states, 1 and 2, where pi 10 bar, v undergoes two processes, a and b, between the sam 0.1 m3, ui-400 kj and p2 1 bar, v2 1.0 m2, u2 200 kj: process a: process from 1 to 2 during which the pressure- volume relation is pv constant process b: constant-volume process from state 1 to a pressure of 2 bar, followed by a linear pressure-volume process to +20 0 state 2 kinetic and potential energy effects can be ignored. for each of the processes a and b, (a) sketch the process on p-v coordinates, (b) evaluate the work, in kj, and (c) evaluate process the heat transfer, in kj
Answers: 2
You know the right answer?
Consider a cmos process for which lmin=0.25um, tox=6nm, mn=460 cm2/v s and vt=0.5v (from problems 5....
Questions
question
Mathematics, 22.02.2021 14:00
question
Mathematics, 22.02.2021 14:00