Engineering, 25.10.2019 22:43 sarahbennett11p4yxlb

Adisplacement transducer has the following specifications: linearity error: ±0.25% readingdrift: ±0.05% /℃ readingsensitivity error: ±0.25% readingexcitation : 10-25 vdc output: 0-5 vdcrange: 0-5 cmthe transducer output is to be indicated on a voltmeter having a stated accuracy of ± 0.1% reading with a resolution of 10 μv. the system is to be used at room temperature, which can vary by ±10○c. estimate an uncertainty in a nominal displacement of 2 cm at the design stage. assume 95% confidence. assume sensitivity is k = 1 v/cm.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

Answer

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

Answer

You know the right answer?

Adisplacement transducer has the following specifications: linearity error: ±0.25% readingdrift: ±...

Questions