subject
Engineering, 25.10.2019 17:43 caliharris123

As a part of producing mosfet transistors, a p-type silicon (si) wafer containing boron (b) dopants at a concentration of 1x10^19 atoms/cm^3 is being processed to create a pn junction by doping the wafer with phosphorous (p) atoms using a p-producing gas. assume that the wafer does not contain p prior to the diffusion process. the solubility of p in si at 1000°c is 1x10^20 atoms/cm^3. it is determined that the pn junction depth of 1 um was produced after 60 minutes at 1000°c. the activation energy for estimating the diffusion coefficient of p in si is 2.5x10^5 j/mole. based on this result, estimate the pre-exponential constant for the diffusion coefficient of p in si at 1000°c in cm^2/s.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 14:10
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
question
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
question
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
question
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
You know the right answer?
As a part of producing mosfet transistors, a p-type silicon (si) wafer containing boron (b) dopants...
Questions
question
History, 02.06.2021 21:30
question
Mathematics, 02.06.2021 21:30
question
Mathematics, 02.06.2021 21:30
question
Mathematics, 02.06.2021 21:30
question
Mathematics, 02.06.2021 21:30