subject
Engineering, 23.10.2019 22:00 ggdvj9gggsc

Atank contains 21 kg of dry air and 0.3 kg of water vapor at 30°c and 100 kpa total pressure. determine (a) the specific humidity(b) the relative humidity (c) the specific enthalpy of the mixture in the tank as (kj/kg-mixture) (calculate by hand)(d) the specific enthalpy of the mixture in the tank as (kj/kg-dry air) (calculate by hand)(e) explain (in 1-2 sentences) the difference between the values in c and d – which value agrees with the enthalpy value in the psychrometric chart at this condition?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
question
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
question
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
question
Engineering, 04.07.2019 18:20
How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s
Answers: 2
You know the right answer?
Atank contains 21 kg of dry air and 0.3 kg of water vapor at 30°c and 100 kpa total pressure. determ...
Questions
question
Mathematics, 25.03.2020 02:09
question
Mathematics, 25.03.2020 02:09