Engineering, 23.10.2019 17:00 tylerkitchen44

Suppose you are looking at the bus routes for chapel hill. it is important that buses arrive on time, and not run late or come too early. you investigate one of the routes and take a 'sample' of 15 circuits, monitoring the time it takes for a bus to complete one full cycle of its route. the mean time to complete the route based on this information was 55 minutes, with a sample standard deviation of 10 minutes. the bus is supposed to take 60 minutes to complete its route. you want to know whether the bus route is completing its route on time with 95% confidence. (assume normally distributed times) construct a null and alternative hypothesis that represents this situation.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

You know the right answer?

Suppose you are looking at the bus routes for chapel hill. it is important that buses arrive on time...

Questions