subject
Engineering, 23.10.2019 04:00 deonharris18

The resistors in the circuit below have the following values: r1 = 7.50 ω, r2 = 7.00 ω, and r3 = 3.90 ω. the two batteries each have a voltage of 3.00 v. a circuit consists of three vertical wires connected at the top and bottom to each other. the left wire contains a resistor labeled r_3. the center wire contains a resistor labeled r_2. the right wire starts at the bottom with a battery labeled emf 2 with its negative pole pointing towards the top, which is then connected to a resistor labeled r_1 which is then connected to the positive pole of a battery labeled emf 1. the negative pole is then connected to the top connection point of the three wires. (a) find the current in through r3. a (b) how much power do the batteries deliver

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
question
Engineering, 04.07.2019 18:10
At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.
Answers: 1
question
Engineering, 04.07.2019 19:10
What is a monomer? how do they form a ploymer from the view point of chemical bonding?
Answers: 1
question
Engineering, 05.07.2019 23:20
Which one of the following faults cause the coffee in a brewer to keep boiling after the brewing cycle is finished? a. an open circuit in the heating element b. a short circuit at the terminals c. welded contacts on the thermostat d. a leak around the gasket
Answers: 3
You know the right answer?
The resistors in the circuit below have the following values: r1 = 7.50 ω, r2 = 7.00 ω, and r3 = 3....
Questions