Engineering, 22.10.2019 21:30 rleiphart1
Asource follower is required to connect a high-resistance source to a load whose resistance is nominally 2 k but can be as low as 1.5 k and as high as 5 k. what is the maximum output resistance that the source follower must have if the output voltage is to remain within ±10% of nominal value? if the mosfet has kn = 2.5 ma/v2 , at what current id must it be biased? at what overdrive voltage is the mosfet operating?
Answers: 1
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Asource follower is required to connect a high-resistance source to a load whose resistance is nomin...
Mathematics, 16.12.2019 23:31
Business, 16.12.2019 23:31
Medicine, 16.12.2019 23:31
Mathematics, 16.12.2019 23:31
Mathematics, 16.12.2019 23:31
Mathematics, 16.12.2019 23:31
Mathematics, 16.12.2019 23:31
History, 16.12.2019 23:31
Mathematics, 16.12.2019 23:31
Spanish, 16.12.2019 23:31